10/2/2023 0 Comments Wired client workgroup![]() ![]() It does not communicate with any other Cisco Aironet wireless networking devices, not even other WGBs, or devices other vendors manufacture. It only communicates to a Cisco AP or Cisco Bridge. ![]() No, the Workgroup Bridge works only with other Cisco equipment. Can Workgroup Bridges work with other IEEE 802.11b devices?Ī. Those that do not immediately become effective are noted in the command information. Most configuration settings become effective as soon as the command is executed. This ensures the configuration is maintained during power failures or intentional power outages. Changes you make are automatically saved to nonvolatile Flash memory each time you set or modify a parameter. There is no explicit method or command to save your configuration changes. How do I save the configurations on WorkGroup Bridge?Ī. It is used in order to attach wired clients to the wireless backbone. No, the Workgroup Bridge is itself a wireless client. Can wireless clients associate to the Workgroup Bridge?Ī. You can also reset the WGB to factory defaults, with the use of a paper clip on the small reset hole, and then use the default address 192.168.200.1 in order to access it if DHCP fails. These default settings apply to a 350 series WGB that run the firmware version 8.89. If an IP address is already configured, you might make a Telnet connection or browse to that IP address. Wired Equivalent Privacy (WEP) is off by default. īy default, the SSID of the Workgroup Bridge is tsunami, and it tries to acquire an IP address over the wireless link through DHCP. IPSU is available at Cisco Downloads ( registered customers only). Install the IP Setup Utility (IPSU) on your PC, then launch IPSU and configure an IP address and Service Set Identifier (SSID) on the Workgroup Bridge. In such cases, configure the Workgroup Bridge with one of these methods. A 340 series WorkGroup Bridge does not have a console connector to configure. Refer to the appropriate procedures explained within the Release notes of different firmware versions for all other vxworks firmware versions. Complete these steps explained in Upgrading Bridge Firmware in order to upgrade a 350 series WGB with its latest firmware version 8.89. The procedure can vary according to the firmware version to which you upgrade as well as the WGB model in which upgrading is done. How do I upgrade the software on a Workgroup Bridge?Ī. You can download the latest software and drivers at the Cisco Wireless Software Center. Cisco Aironet equipment operates best when all the components are loaded with the most current version of the software. Where can I download the latest software?Ī. The WGB connects to a hub through a standard Ethernet port that uses a 10-Base-T connector. In this way, wired clients get access to the wireless network. The WGB associates to the root AP through the wireless interface. Devices that do not have a wireless client adapter in order to connect to the wireless network can be connected to the WGB through the Ethernet port. A Workgroup Bridge (WGB) is a small stand-alone unit that can provide a wireless infrastructure connection for Ethernet-enabled devices. This document provides information on the most common questions asked about Cisco Aironet Workgroup Bridges.Ī. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |